Extron electronic manual Setting the jumpers on AAP transmitters, Cover to the MTP figure

Page 10

Installation, cont’d

Setting the jumpers on AAP transmitters

1.	Remove and retain the two screws that secure the back
	cover to the MTP (figure 2-5).
	2. Carefully pull RJ-45 connector
	through this hole.
	1. Remove these screws.
	OUTPUT
	− + POWER 12V 0.5A MAX
Figure 2-5 — Removing the MTP cover
2.	Pull the cover out of the way, carefully twisting the RJ-45
	connector as necessary to slide it through the hole in the
	cover marked “Output”.
3.	Remove and retain the two standoffs that secure the audio
	board to the main (video) board (figure 2-6). Lift the audio
	board out of the way.

Remove these standoffs.

Figure 2-6 — Removing the audio board

4.	Locate the jumper block (figure 2-7) on the video board.
	Shift the jumper to the alternate location.

Mono (default jumper position)

Compatible with new model receivers.

Cannot remotely power receiver

		Stereo
		Compatible with old model receivers.
		Can remotely power receiver.
Figure 2-7 — Video board jumper locations
5.	Replace the audio board and secure it in place with the
	standoffs removed in step 3.
6.	Feed the RJ-45 connector through the hole in the cover
	marked “Output” and replace the cover. Secure the cover
	in place with the two screws removed in step 1.

	CAUTION	Ensure that the TP cable is not pinched when you
		reinstall the cover.

2-6

VersaTools® MTP Series • Installation

VersaTools® MTP Series • Installation

2-7

Image 10

Contents VersaTools MTP Series Precautions Extron’s WarrantyFCC Class a Notice Table of Contents Introduction Table of Contents, cont’dOne VersaTools MTP SeriesTP Cable Advantages IntroductionAbout the MTP Transmitters and Receivers Transmission DistanceTwo InstallationIntroduction, cont’d Signal Jumpers for Generational Compatibility InstallationSetting the jumpers on non AAP models Installation, cont’d Shift the jumper to the alternate locationSetting the jumpers on AAP transmitters Cover to the MTP figureTabletop use all except AAP models Installation, cont’d Mounting OptionsRack mounting all except AAP models Furniture or projector mounting all except AAP models Frame mounting AAP modelsPanel Features and Connections Transmitter input connectionsTransmitter/receiver throughput connections MTP ReceiversPower connection all models TP cable terminationReceiver output connections Important. The ideal length is 3/16 5 mmThree OperationAAppendix a Front Panel FeaturesTroubleshooting Skew Delay Compensation Reference InformationSpecifications, Part Numbers, and Accessories SpecificationsAudio output audio models A, AV SVA models only Specifications, Part Numbers, Accessories, cont’dGeneral Cables/connectors AAP accessoriesAccessories Skew compensation solutionsSpecifications, Part Numbers, Accessories, cont’d