Pioneer PDP-507XD manual Connecting to an antenna, Attaching speed clamps to the main unit

05Preparation

Attaching speed clamps to the main unit

Attach the speed clamps using any of the 4 holes you prefer (50

inches, 3 holes: 42 inches, 2 holes) marked with below, depending on your routing system.

for PDP-607XD

for PDP-507XD

Attaching and removing speed clamps

Insert [1] into an appropriate hole on the rear of the Plasma Television and snap [2] into the back of [1] to lock the clamp. Speed clamps are designed to be difficult to undo once in place. Please attach them carefully.

Use pliers to twist the clamp 90º, pulling outward. The clamp may deteriorate over time and become damaged if removed. Be careful not to subject any connecting cables to strain.

NOTE

• Use the supplied speed clamps as necessary.

for PDP-427XD

Connecting to an antenna

To enjoy a clearer picture, use an outdoor antenna. The following is a brief explanation of the types of connections that are used for a coaxial cable.

Standard DIN45325 plug (IEC169-2)

75-ohm coaxial cable (round cable) (commercially available)

IN

3 4

•For viewing both analogue and digital broadcasts, connect the antenna cable to the ANT OUT terminal (antenna through out) and ANT (analogue input) terminal.

•If “Aerial Power” setting is enabled, use an indoor antenna with signal amplifier, 5 V 30 mA.

OUT

3 4

• For viewing analogue broadcasts only, connect the 75-ohm coaxial cable (commercially available) to ANT (analogue input) terminal.

Antenna cable (commercially available)

If your outdoor antenna uses a 75-ohm coaxial cable with a standard DIN45325 plug (IEC169-2), plug it into the antenna terminal at the rear of the Plasma Television.

20

En