Regency E33-LP Installation, Excalibur Surround, Width at front, 34-1/2876mm, Depth, 17-3/4451mm

INSTALLATION

5) Install Spring Hinges to the Left and Right	EXCALIBUR SURROUND	3) Hold the Faceplate Trim up against the unit
Side of the bottom of the fi rebox using 2	INSTALLATION	in order to make the following wire connec-
screws per hinge.		tions.
		3a) Pull the ON/OFF connector wires from the
	IMPORTANT NOTE:	fi rebox and connect them to the switch.
	When using the Surround, the unit must be set 1"
	further into the fi replace than the standard face-	3b) Connect the fan switch wires with the wire
	plate installation. See page 6 for the Minimum	connectors from the fan speed control. Place
	Fireplace Opening Excalibur Option.	clips over wires and tuck into side trim.

1)Align the left side Faceplate Trim Bracket

with the Firebox Flange and secure using

	2 screws as shown in diagram 1. Repeat	ON/OFF
		switch
	for right side.
		Fan Speed
6) Place Bottom Frame near hinge. Flip hinge	wires to	Switch
		(Rear View)
	ON/OFF
overBottomFrameandsecurewith3screws
	switch	wires to
each.
		Fan switch
	for gas	connectors
Hinge Location	connection	Self-adhesive
		wire clip

Bottom Frame

	Firebox		4) Secure the Faceplate by sliding the slots in
Faceplate	Flange		the Faceplate into the flanges on the left and
			rightsideFaceplateTrim Brackets. Oncethe
Trim Bracket
			Faceplate is in place secure using 2 screws
	Diagram 1	Faceplate
			per side.
		Trim Bracket

7)Install the Left and Right Side Screen Doors by placing over top of the hinges on the faceplate. Hold the door at a 45 degree angle to avoid scratching the faceplate.

8)Close screen doors.

Hinge

Screen Door

2)Push the Blanking Plate down on top of the Glass Door (refer to Diagram 2).

Blanking Plate

Top of

Glass

Door

Diagram 2

Faceplate

Slots

NOTE: If you are installing the Excalibur, the minimum fireplace dimensions are as follows:

Width (at front):	34-1/2" (876mm)
Depth:	17-3/4" (451mm)
Height:	26"	(660mm)

E33 FPI Direct Vent Gas Insert 15