Pioneer PDP-507XD manual Using Hdmi Input, Connecting Hdmi equipment

Enjoying through External Equipment 12

Using HDMI Input

This Plasma Television is equipped with two HDMI terminals (INPUT 3 and 4) which accept digital video and audio signals. To use the HDMI terminal, activate the terminal and specify the types of video and audio signals to be received from the connected equipment. For the types of these signals, see the operation manual that came with the connected equipment. Before starting the menu, press INPUT 3 or INPUT 4 on the remote control unit or press INPUT on the Plasma Television to select INPUT 3 or INPUT 4.

Input signal table

1920*1080i@50 Hz

720*576p@50 Hz

1280*720p@50 Hz

720(1440)*576i@50 Hz

1920*1080i@59.94 Hz/60 Hz

720*480p@59.94 Hz/60 Hz

1280*720p@59.94 Hz/60 Hz

720(1440)*480i@59.94 Hz/60 Hz

1920*1080p@24 Hz

For audio, the system supports the following:

•Linear PCM (STEREO 2ch)

•Sampling frequency: 32 kHz, 44.1 kHz, 48 kHz

NOTE

•PC signals are out of correspondence.

•It may take time until an image is displayed depending on the equipment connected.

Connecting HDMI equipment

When using the INPUT 3 HDMI terminal:

Plasma Television (rear view)

3 4

HDMI cable having the HDMI mark (commercially available)

SCART cable (commercially available)

Connect the SCART cable only when inputting analogue audio signals.

HDMI equipment

When using the INPUT 4 HDMI terminal:

Plasma Television (rear view)

English

3 4

HDMI cable having the HDMI mark (commercially available)

HDMI equipment

To activate the HDMI terminal:

When you use the INPUT 3 HDMI terminal, use the following procedure to activate the terminal.

1Press HOME MENU.

2 Select “Option” (/ then ENTER).

3 Select “HDMI Input” (/ then ENTER). 4 Select “Setting” (/ then ENTER).

5 Select “Enable” (/ then ENTER).

ItemDescription

Disable	Deactivates the HDMI terminal.
(factory default)
Enable	Activates the HDMI terminal.

6Press HOME MENU to exit the menu.

NOTE

•You need not activate the INPUT 4 HDMI terminal; you cannot manually deactivate this terminal.

To specify the type of digital video signals:

1Repeat steps 1 to 3 provided for “To activate the HDMI terminal.”

2 Select “Video” (/ then ENTER).

3 Select the type of digital video signals (/ then ENTER).

•If you select “Auto”, an attempt will be made to identify the type of digital video signals when digital video signals are received.

ItemDescription

Auto	Automatically identifies input digital video signals.
(factory default)
Colour-1	Digital Component Video signals (4:2:2) locked
Colour-2	Digital Component Video signals (4:4:4) locked
Colour-3	Digital RGB signals locked
4 Press HOME MENU to exit the menu.		59

En