Pioneer PDP-507XD manual Checking signal strength, Restoring the system defaults

Enjoying DTV broadcasts 09

Add New Channels
Search Information		Found Channels
Existing Channels	04	001	************
Channels Found	20	002	************
Progress	30%	003	******
		004	************

•To quit a channel search in progress, press HOME MENU.

NOTE

•The password entry screen does not appear if you have disabled the password function. For details, see “Using a password (AV mode only)” on page 56.

•You can select “DTV Setup” only when watching DTV channels.

Checking signal strength

You can check the signal strength and signal quality of each TV channel.

1Repeat steps 1 to 4 provided for “Adding New Channels”.

2Select “Signal Check” (/ then ENTER).

3Select “RF Channel” (/ then ENTER).

4Select the channel to be checked (/ ).

Signal Check

RF Channel				21
Add New Channels
Signal Strength :		77%
0	25		50	75	100
Signal Quality :		100%	Good

•Use “Add New Channels” function here to add channels within the selected RF channel (receiving frequency).

3Select “On” or “Off” (/).

Installation

Aerial Power	Off
Country	Germany

Add New Channels

Replace Existing Channels

Signal Check

Restore System Defaults

NOTE

•You can select “DTV Setup” only when watching DTV channels.

Restoring the system defaults

Use this function only when you wish to reset all the DTV settings to the factory defaults.

1Press HOME MENU.

2Select “Setup” (/ then ENTER).

3Select “DTV Setup” (/ then ENTER).

4Select “Installation” (/ then ENTER).

•The password entry screen appears. Enter your 4-digit password using buttons 0 to 9.

5Select “Restore System Defaults” (/ then ENTER).

• A confirmation screen appears.

6With “OK” pressed, the system restores the factory defaults. Then Auto Installation is initiated automatically.

NOTE

•The password entry screen does not appear if you have disabled the password function. For details, see “Using a password (AV mode only)” on page 56.

•You can select “DTV Setup” only when watching DTV channels.

English

NOTE

•You can select “DTV Setup” only when watching DTV channels.

Switching on/off the power to the antenna

Use the following procedure to switch on or off the power to the antenna connected with the DTV antenna terminal.

1Repeat steps 1 to 4 provided for “Adding New Channels”.

2Select “Aerial Power” (/).

41

En