Pioneer PDP-507XD Watching TV, Turning on/off the power, Plasma Television status indicators

06Watching TV

Unless you set up TV channels that you can watch under the current conditions, you cannot tune in those channels. For the procedure, see “Setting up TV channels automatically” on page 29.

Plasma Television (PDP-607XD)

Turning on/off the power

NOTE

•When the Plasma Television is plugged into a power outlet, it is placed into the standby mode; the STANDBY indicator on its front panel should flash red. The Plasma Television stays in the standby mode unless it is unplugged from the power outlet.

To turn on the system, press POWER on the Plasma Television.

•The POWER ON indicator on the Plasma Television lights up in blue.

To turn off the system, press aon the remote control unit or STANDBY/ON on the Plasma Television.

•The Plasma Television is placed into the standby mode; the STANDBY indicator lights up in red.

•You can then turn on the system again by pressing aor 0 to 9 on the remote control unit or STANDBY/ON on the Plasma Television. If you press 0 on the remote control unit, images come from the INPUT 1 source. If you press 1 to 9, TV images display.

You can also press POWER on the Plasma Television to turn off the system. However, you cannot then turn on the system again by pressing the buttons on the remote control unit and Plasma Television.

NOTE

•Before operating with the remote control unit, make sure to select the TV mode using its SELECT button. See “Controlling other equipment using the supplied remote control unit” on page 64.

•It is recommended not to unplug the Plasma Television from a power outlet when it is not in use. When in the standby mode, the Plasma Television automatically receives Electronic Programme Guide and DTV Auto Update signals.

•When the system is placed into the standby mode, the main power flow is cut and the system is no longer fully operational. A minute flow of power feeds the system to maintain operation readiness.

•If you are not going to use the Plasma Television for several days, be sure to remove the power cord from the power outlet.

Plasma Television status indicators

The table below shows the operational status of the Plasma Television. You can check the current status of the system with the indicators on the Plasma Television.

Indicator Status System Status

POWER ON STANDBY

The power cord of the Plasma Television has been disconnected. Or, the power cord of the Plasma Television has been connected but the POWER button of the Plasma Television is off.

Power to the system is on.

The system is in the standby mode.

For other than the above, see “Troubleshooting” on page 71.

22

POWER button

POWER ON indicator

STANDBY indicator

POWER ON STANDBY TIMER

(PDP-507XD)

POWER button

POWER ON indicator

STANDBY indicator

POWER ON STANDBY

(PDP-427XD)

POWER ON indicator

STANDBY indicator

ON STANDBY TIMER

POWER button

Viewed from below of the display (left)

1 2 3 4

INPUT

1 2 3

4 5 6

7 8 9

				INFO
PC		0
INPUT 5
		TV/DTV
P
SELECT	TV	DVD/	VCR	SOURCE
		STB DVR

En