Desa VMH10RNC Attaching Wood Base to Solid Floor, Connecting to GAS Supply, Included, Door

INSTALLATION

Continued

Wire Harness

Blower Bracket

Assembly

Screw

Clamp

Connector

(not included)

Switch

Power Cord

3 2 1

Switch

Plate

Red	Blue
Black	Plastic	Outlet
	Wire
	Strap Wire	Receptacle (not
		included)

Harness	Lower Louver
	Door
Figure 19 - Installing Blower (Thermostat Unit Shown)

ATTACHING WOOD BASE TO SOLID FLOOR

For attaching base to solid floors (concrete or masonry)

Note: Floor anchors and mounting screws are in hardware package. The hardware package is pro- vided with fireplace.

1.Drill holes at marked locations using 5/16" drill bit. For solid floors (concrete or ma- sonry), drill at least 1" deep.

2.Fold floor anchor as shown in Figure 20.

3.Insert floor anchor (wings first) into hole. Tap anchor flush to floor.

4.Insert mounting screws through base and into floor anchors.

5.Tighten screws until base is firmly fastened to floor.

CONNECTING TO GAS SUPPLY

WARNING: This appliance re- quires a 45° male flare fitting 5/8"- 18 UNF (Unified National Fine Thread) inlet connection and the flexible gas line provided.

WARNING: A qualified ser- vice person must connect fire- place to gas supply. Follow all local codes.

WARNING: Never connect natural gas fireplace to private (non-utility) gas wells. This gas is commonly known as well- head gas.

Figure 20 - Folding Anchor

112462-01C www.desatech.com 17