INSTALLATION
Continued
Mantel Shelf
Note: | 10" | |
8" | ||
All vertical | ||
measurements | 6" | |
are from top of | ||
2 1/2" | ||
fireplace |
opening to bottom of mantel shelf. All measurements are in inches.
13" | 16" | 19" | 21" |
Side of Firebox
Figure 10 - Minimum Mantel Clearances
for
OPTIONAL MANTEL INSTALLATION
Note: Refer to instructions provided with the man- tel for assembly instructions. Refer to the follow- ing instructions for system installation. Refer to instructions on page 5 for fireplace assembly. Blower accessory should be installed if it is being used (see Installing Blower Accessory GA3450T, page 14).
1.Unscrew four screws that attach top louver to fireplace. Remove louver from fireplace and set aside.
2.Place fireplace on wood base.
3.Place mantel around fireplace/base assembly.
4.Assemble trim kit. See Assembling Trim, page 14.
5.Firmly snap trim kit on shoulder screws. Shoulder screws are located on fireplace cabi- net (see Figure 11).
6.Align trim kit for flush fit around opening.
7.Use two 3" wood screws provided and attach fireplace base to wooden base. There are holes provided on each side and floor of firebox (see Figure 11).
8.Place base assembly next to wall at installa- tion location.
9.Remove trim kit and mantel. Be careful not to damage wall or mantel.
10.Attach wood base to floor with two 1 3/4" black screws provided (see Figure 12). If the floor is concrete use anchor method (see Attaching Wood Base to Solid Floor, page 17).
11.Install gas line. See Connecting To Gas Sup- ply, page 17.
12.Check for leaks. See Checking Gas Connec- tions, page 19.
13.Place mantel around fireplace. Be careful not to damage wall or mantel.
14.Place trim kit on the shoulder screws located on the side and top of the fireplace. Firmly snap the trim over the shoulder screws on fire- place (see Figure 11).
15.Adjust assembly to remove any gaps. Attach remaining two 3" wood screws from hardware pack through openings inside of fireplace sides into the mantel. The openings are located at top behind the area for the louvers (see Figure 11).
16.Reinstall top louvers.
Shoulder Screws | Hole for | |
Attaching | ||
| ||
| Fireplace | |
| to Mantel |
Assembled | Shoulder |
Trim | Screws |
Figure 11 - Attaching Trim to Fireplace
1 3/4" Screw
Wood Base
Figure 12 - Attaching Wood Base to
Floor
www.desatech.com | 13 |
