ASSEMBLY
WARNING: Always have screen in place before operat- ing fireplace. This prevents ex- cessive temperatures on fire- place surfaces.
WARNING: Failure to posi- tion the parts in accordance with these diagrams or failure to use only parts specifically approved with this fireplace may result in property damage or personal injury.
ASSEMBLING FIREPLACE
Tools Required:
•Phillips screwdriver
•5/16" hex wrench
•slotted screwdriver
•scissors
1.Remove two screws that hold fireplace screen in place for shipping. These screws are located near top of screen. Discard screws. Lift fire- place screen up and pull out to remove (see Figure 2). Set screen aside until installation has been completed.
2.Cut two plastic straps to remove the log from the firebox cavity.
3.An optional blower is available. See Acces- sories, page 40. Install optional blower now. Follow installation instructions provided with blower. See Installing Optional Blower Ac- cessory GA3450T on page 14.
Shoulder
Screw
Screen
4.Locate four black phillips sheet metal screws from the hardware packet.
5.Rotate hood as shown in Figure 3. Make sure hood tabs point toward fireplace.
6.Insert hood tabs between baffle and louvers (see Figure 3).
7.Gently rotate hood to upright position. Make sure hood tabs are behind louvers and hood is resting on firebox top (see Figure 3).
8.Align screw holes on hood with screw holes on firebox top.
9.Insert screws as shown in Figure 3. Tighten screws firmly.
Hood Tabs
Hood
Louver
Hood Tab
Baffle
Sheet Metal
Screws
Firebox Top
Figure 3 - Assembling Hood
Figure 2 - Removing Screen
6 | www.desatech.com |
