Extron electronic PVS 204SA Rear Panel Features and Cabling, Power connection, Input connections

Installation

Rear Panel Features and Cabling

2 3 4 10

RGBVIDEO

1A 2A 3

	I
	N
POWER	P
	U
	T
	S

12V	1B	2B	4
3A MAX

1

RGB

O

U

T

P

U

T

S

VIDEO

5

		LISTED 17TT			AMPLIFIED OUTPUTS
®	US AUDIO/VIDEO					4/8
		APPARATUS
						Ohms
					L	R
	ON	STEREO	AUX/MIX IN	RS-232 MLC/IR		DC VOL
HIGH				Tx Rx IR	12V
	ON
PASS
FILTER				A B C
	OFF	DUAL				10V
		MONO				VOL/MUTE

6 7 8 9

Figure 2-2 — Features of the PVS 204SA Switcher rear panel

Power connection

A DC power connector — Attach the supplied male captive screw connector to the cord of the included power supply as shown in figure 2-3.

PRELIMINARY

Smooth	Ridges
A	A

SECTION A–A

Power Supply
Output Cord	Tie Wrap

Captive Screw

Connector

3 "

16 (5 mm)

Figure 2-3 — Wiring the orange captive screw power connector

When all other cables have been connected, plug the captive screw connector into the 2-pole female connector (A) to connect the switcher to the 12 VDC power source. The front panel power LED () lights while the PVS is receiving power.

NUse only the supplied 12 V power supply for this switcher.

A/V input connections

BB RGB video and audio inputs (“RGB”) — Each RGB input requires			1A
		RGB
the use of two twisted pair cables. Using the TP cables, connect one	I
or two high resolution computer video and audio sources via PVT	N
	P
transmitters to these four RJ-45 female connectors.	U
	S
	T

CThe PoleVault signal transmission method is specific for

PVS 204SA switchers working with PVT transmitters. 1B

DO NOT connect to an MTP system.

DO NOT connect to an Ethernet/LAN or data transmission system.

NThe PVS 204SA can receive signals from PVT transmitters located up to 100 feet (30 m) away. The optimum distance is between 50 (15 m) and 75 feet (23 m). The minimum distance is 15 feet (5 m).

2-4 PVS 204SA Switcher • Installation