Extron electronic PVS 204SA manual Speaker Configuration, Speaker arrangement examples

Page 23

J	Amplified Out — Wire and connect the supplied 4-pin 5 mm
	connector to this port, marked “L” and “R” (left and right) for
	4 or 8 ohm speaker output.

AMPLIFIED OUTPUTS
	4/8 Ohms
L	R

CDo not tie both L and R outputs to each other and/or to ground. Doing so will short out the outputs and damage the amplifier.

NThe speaker setup covers two individual speakers of 8 ohm impedance or two pairs of speakers in parallel where each channel drives a maximum output load of 4 ohms

Speaker Configuration

Speaker arrangement examples

Ceiling and program speakers can be arranged several different ways.

The following factors affect the choice of speaker placement:

•Dimensions of the room

•Room acoustics

•Desired evenness of sound coverage

•Audience mobility (whether the audience will be seated or not)

•Ambient noise level

•Type of music or other audio source

Some general ideas for speaker placement are included below.

Program Speakers

Ceiling

Speakers

Classroom Top View	Classroom Top View
2 Front Program Speakers	4 Ceiling Speakers

Figure 2-15 — Examples of speaker layouts

PVS 204SA Switcher • Installation 2-11

Image 23

Contents PVS 204SA PoleVault SwitcherSicherheitsanleitungen Deutsch PrecautionsSafety Instructions English Consignes de Sécurité FrançaisFCC Class a Notice Quick Start PVS 204SAQuick Start PVS 204SA, cont’d Table of Contents Table of Contents, cont’d One About the PVS 204SA PVS 204SA Switcher IntroductionIntroduction About this ManualFeatures Introduction, cont’d Application DiagramsMLP 101 AAP Introduction, cont’d Two PVS 204SA Switcher Installation InstallationUL/Safety Guidelines Important safety instructionsInstalling the PVS 204SA on the PMK Mounting the SwitcherInput connections Rear Panel Features and CablingPower connection Twisted pair RGB video and audio cable wiring Output connections Installation, cont’dAs shown at right Aux/Mix input connectionControl connection RS-232/MLC/IR control port The PVS switcher can beConfigured with a driver to 12 Connecting an IR Link to the switcher Speaker arrangement examples Speaker ConfigurationStereo or Dual Mono Output using parallel speaker wiring Connecting speakers to the PVS 204SALabeling the A/V Inputs Labeling and connecting the A/V input cablesLabeling the PVT Decora face plates Final SetupThree PVS 204SA Switcher Operation and Setup Operation and SetupFront Panel Features and Operation Setting the single switcher mode via the front panel Setting Switcher ModesSingle switcher mode Separate switcher modeSetting the input auto switching mode via the front panel Auto SwitchingSetting the separate switcher mode via the front panel Steps for optimizing the audio Setting Up and Optimizing the AudioAmplifier level control Front panel input sensitivity adjustmentGain control Individual channel input sensitivity controlAux/Mix control Resetting the SwitcherClipping indicator Bass, treble, and loudness controlSetting the executive mode via the front panel Front Panel Security Lockout Executive ModeFour PVS-initiated messages Serial CommunicationRS-232 Programmer’s Guide Host-to-PVS communicationsSymbol definitions Error responsesUsing the command/response tables Serial Communication, cont’d Factory defaultsCommand Ascii Command Response Additional description Command/response table for SIS commandsVolume adjustment Status commandsCommand Ascii Command Response ? values Command/response table for special function SIS commandsUpdating Firmware Click Upload to upload the firmware file into the PVS 204SA Preliminary Reference Material Reference Material PVS 204SA Switcher Reference MaterialVideo output composite video Reference Material, cont’d Included parts Part Numbers and AccessoriesAccessories Accessory Part number Speaker accessoriesCable accessories Reference Material Audio Block DiagramDBV Voltage DBu Audio Reference LevelsExtron’s Warranty Extron USA West