Back of the rack installation

Installation and Operation

MDA S

ERIES

Mounting the YCV 100, VYC 100N, and VYC 100P on a 1U standard rack shelf

The YCV 100, VYC 100N, and VYC 100P can be conveniently mounted on the rear of a rack by using the Extron back of the rack mounting kit (MBB 100, Extron part #70-367-01). The back- of-the-rack mounting kit allows the device to be vertically positioned.

1.Attach the two back of the rack mounting brackets to the sides of the unit using the four included mounting screws.

IPA T

IPA

IPA T

IPA

2.Mount the unit on the rack using the two included rack screws. It can be vertically mounted facing in either direction, as shown here.

3	INPUTS	+
4	INPUTS	+
		R
	5	L
		6
		7
		8
		1
		2
		3
		OUTPUTS
		4
		5
		6
		7
		8
		M
		AV S
		ERI
		ES

Furniture mounting

Furniture mount the YCV 100, VYC 100N, or VYC 100P using the optional MBU 123 mounting kit (part #70-212-01) as follows:

1.	Remove rubber feet if they were previously installed on the
	bottom of the unit.
2.	Attach the furniture mounting brackets to the unit with the
	machine screws provided.
3.	Hold the unit with the attached brackets against the
	underside of the table or other furniture. Mark the location
	of the screw holes of the bracket on the mounting surface.
4.	Drill 3/32" (2 mm) diameter pilot holes, 1/4" (6.3 mm) deep
	in the mounting surface at the marked screw locations.
5.	Insert #8 wood screws into the four pilot holes. Tighten
	each screw into the mounting surface until just less than
	1/4" of the screw protrudes.
6.	Align the mounting screws with the slots in the brackets and
	place the unit against the surface, with the screws through
	the bracket slots. See the illustration below.

7.Slide the unit slightly forward or back, then tighten all four

screws to secure the unit in place.

2-4

YCV 100, VYC 100N, VYC 100P • Installation and Operation

2-5