Extron electronic SW12 VGA ARS, SW8 VGA Ars manual Mounting through a desktop

Page 16

Mounting through a desktop

Through desktop mounting requires the included MBD 149 1U, through-desk and rack mounting kit (part #70-077-03).

Mount an SW8/12 VGA Ars unit through a desktop as follows:

1.	If present, remove the four rubber feet from the bottom of the unit.
2.	Cut an appropriately sized hole in the desktop.
3.	Loosely install the mounting brackets on the unit’s sides with four machine
	screws provided in the kit.
4.	Hold the unit (with brackets attached) against the underside of the desk.
	Mark each bracket's hole location on the underside of the desk.
5.	Drill 1/4" (6.4 mm) deep, 3/32" (2 mm) diameter pilot holes from the
	underside of the desk at the marked hole locations.
6.	Hold the unit in place so the mounting bracket holes line up with the pilot
	holes in the desktop.
7.	Install the four supplied wood screws through the mounting brackets and into
	the pilot holes.
8.	Tighten the wood screws to secure the mounting brackets to the underside of
	the desktop.
9.	Slide the switcher up or down inside the mounting brackets to achieve the
	desired height above the desktop.
10.	Tighten the machine screws to secure the switcher in position.

Figure 2-3 — Mounting the switcher through a desktop

SW8/12 VGA Ars • Installation and Operation

2-5

Image 16

Contents Computer Video and Audio Switchers SW8/12 VGA ArsPrecautions Safety Instructions EnglishConsignes de Sécurité Français Sicherheitsanleitungen DeutschFCC Class a Notice Quick Start SW8/12 VGA Ars SW8/12 VGA Ars Quick Start QS-1Quick Start SW8/12 VGA Ars, cont’d QS-2 SW8/12 VGA Ars Quick StartTable of Contents Table of Contents, cont’d One About the SW8/12 VGA Ars Switchers IntroductionAbout This Manual SW8/12 VGA Ars IntroductionFeatures Introduction, cont’d Two Installation and Operation Mounting the SW8/12 VGA Ars SwitcherDesktop placement Rack mountingMounting instructions Rack mount an SW8/12 VGA Ars unit as followsInstallation and Operation, cont’d Mounting under a desktopMounting through a desktop Cut an appropriately sized hole in the desktopRear Panel UXGA, QXGA, or HdtvCable Connections Power connectionComputer video input connections Audio input connections Pin Name Connection 5mm Stereo ConnectorVideo output connections Remote control connection Audio output connections10 SW8/12 VGA Ars Installation and Operation VSW I AAP connection15 a typical switcher application w/VSW I AAP units IR 102 remote control connection 12 SW8/12 VGA Ars Installation and OperationFront Panel Hold Press Description and ResultOperating the SW8/12 VGA Ars Switchers 14 SW8/12 VGA Ars Installation and OperationThree Remote Control via Simple Instruction Set SIS\⤀ Switcher-initiated unsolicited\⤀ messagesPin RS-232 Description RS-232 Control Port Connector ControlError responses TimeoutUsing the command/response table Symbol definitionsCommand/Response Table for SIS commands Command Ascii Telnet Response Additional descriptionUpload firmware Updating Firmware Downloading the firmwareLoading the firmware to the switcher \Program Files\Extron\FWLoaderExtron firmware loader screen Extron’s firmware loader screen 10 SW8/12 VGA Ars Control Specifications, Part Numbers, Accessories Specifications Specifications, Part Numbers, AccessoriesSW8/12 VGA Ars Specifications, Part Numbers, Accessories Audio input Part Numbers and Accessories SW8/12 VGA Ars switchersAccessories Included partsExtron’s Warranty Extron Electronics, Europe Beeldschermweg 6C

Related manuals

Manual 41 pages 19.76 Kb