Extron electronic TSC 100 user manual Control Software for Windows, Installing the software

Serial Control, cont’d

Additional description
Response	(TSC 100 to host)

ASCII Command (host to TSC 100)

Command

Show Color Bars test pattern. Remove Color Bars test pattern.

Tst1 Tst0

	1J	0J
Miscellaneous commands	Test Pattern: Enable color bars	Disable color bars

X4

J

View status

Zpx Reset everything: all settings and adjustments revert to factory default. Shows the controller firmware version. Displays the Extron part number.

Esc zXXX x.xx XX-XXX-XX

	q/Q	n/N
Reset: ZAP (reset to default settings)	Information Requests: Query software version	Request part number

C X1 •Typ X5Typ X5 displays the type of input

i/I

Request information

sensed by	changed.
automatically	This cannot be
signal that is	the decoder.

Command/Response Table for Special Function SIS Commands

The syntax for setting a special function is X? * X! # , where X? is the function number and X! is the value. To

view a function’s setting, use X? #, where X? is the function number. In the following table, the values of the X?

variable are different for each command/function. These values are given in the rightmost column.

0 = Off (default), 1 = On.

Aut X4

10* X4 #

Autoswitch

Enable autoswitch mode.

Aut 1

10*1#

Example

0 = Off (black screen with no input

Blk X! #

2 * X! #

Color bars

signal).	(Color Bars Display on output)	Color Bars Display on output.
	1 = On	Enable

Blk 1

2*1#

Example

x! = 1, 2, or).3 (see Figure 7

Asp X!

5* X! #

Aspect Ratio

Enable aspect ratio #1.

Asp 1

5*1#

Example

			Preset #3
NTSC Converted	Preset #1	Preset #2	Scale Down
to PAL	Center Horizontally	Scale Up Vertically	Horizontally
NTSC	PAL	PAL	PAL
			Preset #3
PAL Converted	Preset #1	Preset #2	Scale Up
to NTSC	Center Horizontally	Scale Down Vertically	Horizontally
PAL	NTSC	NTSC	NTSC

Figure 7 — Aspect Ratio Presets

Control Software for Windows

The included graphical control software for Windows offers another way to control the TSC 100 via RS-232/422 in addition to the Simple Instruction Set commands listed on the previous pages. The TSC 100 uses Extron’s Signal Enhancement Products Control Program, which is included with these interfaces. The control software is compatible with Windows 3.1x, Windows 95/ 98, and Windows NT.

Installing the software

To install the software onto the hard drive, run SETUP.EXE from the floppy disk, and follow the instructions that appear on the screen. The program requires approximately 2 MB (megabytes) of hard disk space.

By default the installation creates a C:\TSC 100 directory, and it places two icons (TSC 100 Control Pgm and TSC 100 Help) into a group or folder named “Extron Electronics”.

Using the software

To run the control program, follow these steps:

1. Double-click on the TSC 100 Control Pgm icon in the Extron Electronics group. The Comm menu will appear on the screen.

3-8 TSC 100 • Serial Control TSC 100 • Serial Control 3-9