Extron electronic TSC 100 user manual Table of Contents

Quick Start Guide — TSC 100, cont’d

Step 6

Select an input and an output standard using the front panel buttons or the RS-232 controller.

Step 7

The picture should now appear. If not, ensure that all devices are plugged in and receiving power. Check the cabling and make adjustments as needed. Select a different input to check for a display.

Optimizing the Video

Step 1

Complete the basic setup (described above) and obtain a picture on the output display.

Step 2

Select Aspect Ratio Preset or size and center the image through the control program (see to page 2-6), if needed.

Step 3

Adjust top and bottom blanking, if needed, to remove edge noise.

Step 4

Using the Picture Controls button, select Brightness, then adjust the level using the Adjust knob.

Step 5

Using the Picture Controls button, select Contrast, then adjust the contrast using the Adjust knob.

Step 6

Using the Picture Controls button, select Color, then adjust the color using the Adjust knob.

Step 7

Using the Picture Controls button, select Tint, then adjust the tint using the Adjust knob (see example illustration below).

			B. Adjust using knob.
		PICTURE	ADJUST
INPUT	OUTPUT	CONTROLS	COLOR
			TINT
	1	NTSC	BRIGHT
			MIN/
	2	PAL	CONTRAST
			MAX
			TSC 100
		TRANSCODING STANDARDS CONVERTER

A. Press to select tint.

Table of Contents

Chapter 1 • Introduction	1-1
About the TSC 100	1-2
Features	1-2
Chapter 2 • Installation and Operation	2-1
Rack Mounting the TSC 100	2-2
Connections	2-3
Rear panel connections	2-3
Cabling the TSC 100	2-4
Operation	2-4
Front panel controls and indicators	2-5
Presets	2-6
Troubleshooting	2-6
Chapter 3 • Serial Control	3-1
Programmer’s Guide for Serial Communication ...	3-2
Device-initiated messages	3-2
Error responses	3-2
Using the command/response table	3-3
Symbol definitions	3-3
Command/response table for SIS commands	3-5
Command/response table for Special Function SIS commands
................................................................................................	3-9
Control Software for Windows®	3-9
Installing the software	3-9
Using the software	3-9
Using the help system	3-10
Appendix A • Specifications, Part Numbers,
and Accessories	A-1
Specifications	A-2
Parts	A-4
Included Parts	A-4
Accessories	A-4
Cables	A-4
Adapters	A-4

All trademarks mentioned in this manual are the properties of their respective owners.

68-623-01

Rev. C

12 04

QS-2 TSC 100 • Quick Start Guide TSC 100 • Table of Contents i