Installation and Operation, cont’d
All IR control signals are sent to all devices (video sources, projector, etc.) at the same time even if two or three IR Emitters or an IR Broadcaster are installed. The IR sending devices share the same IR Display/Control port on the MLC.
•For RCM modules, ensure that the wiring from the MLC to the screen motor’s low voltage controller is correct. Refer to the screen manufacturer’s user’s guides. For the
5.Call the Extron S3 Sales and Technical Support Hotline if the item(s) being controlled still does (do) not respond when the control module’s buttons are pressed.
Mounting the Control Module Into an AAP Wallplate or Device Faceplate
The control module and any other adapter plates must be attached to a device faceplate or AAP wallplate and cabled before the device or wallplate is installed in a wall or furniture. The screws needed for installing the control module are built into its front panel, so no additional screws will be needed.
1. | Before any cables are attached, insert the control module’s |
| screws through the holes in the device’s faceplate or AAP |
| wallplate. Secure the control module to the faceplate/ |
| wallplate with the provided captive washers and |
| nuts. |
2. | Follow steps 5 through 12 in the “Installation Overview” |
| section of this chapter. |
3.If the control module is not installed into a grounded metal wall box, ground the faceplate before fastening the faceplate into the wall or furniture.
Do not tie a module’s faceplate to both a separate earth ground and the circuit ground (via a connector pin). If you tie a product to two different ground sources, you may introduce ground loops or other
Relay Control Modules
AAppendix A
Specifications, Part Numbers,
Accessories, and Dimensions
Specifications
Included Parts
Accessories
Cables
Dimensions