DVI 104 Tx/Rx, cont’d
Trouble Shooting
Display does not show an image
•Ensure that all plugs and jacks used by the external power supplies are firmly connected.
If the cable is loose or slips out of the slot easily, move the release catch from its normal position above the locking catch, to the adjusted position under the locking catch (see the figure below). This provides the extra leverage required to keep the locking catch in place and hold the cable securely.
Locking catch | Release catch |
Normal Position
Adjusted Position
•Ensure that the blue LEDs for both the transmitter and receiver are on.
•Ensure that the correct EDID information has been stored on the transmitter’s EDID Minder. When using the DVI 104 Tx/Rx for the first time or if the display device is changed, it is essential to set up the EDID Minder as described in steps
•Ensure that the source device and output device are powered on and have booted correctly.
•Ensure that the fiber optic cables are connecting the correct ports. A port on the transmitter must be connected to the same numbered port on the receiver. For example,
port 1 of the transmitter must be connected to port 1 of the receiver.
•Ensure that the fiber optic cable jacks are securely seated.
8DVI 104 Tx/Rx • User’s Guide