General Operation, Mains, Radio Reception

English

GENERAL OPERATION

MAINS

1.Check if the mains voltage as shown on the type plate (on the bottom of the set) corresponds to your local mains

voltage. If it does not, consult your dealer or service organization.

2. Connect the mains lead to the AC MAINS ~ socket and the wall socket.

™The set is now ready for use.

3.To switch off the mains supply completely, pull the mains plug out of the wall socket.

™Disconnect the mains lead when you change over to battery supply, or to protect the set during heavy thunderstorms.

The type plate is located on the bottom of the set.

GENERAL OPERATION

1.To switch on the set, adjust the source selector.

2.Adjust the sound using the VOLUME and DBB controls.

3.To switch off the set, adjust the source selector to the TAPE/OFF position, with the cassette keys released.

RADIO RECEPTION

1.Set the source selector to TUNER.

2. Adjust BAND to FM or MW as your desired band.

3. Adjust the sound using the VOLUME controls and the DBB switch.

4. Tune to a radio station using the TUNING knob.

– For FM, pull out the telescopic aerial. To improve FM-reception, incline and turn the aerial. Reduce its length if the FM-signal is too strong (very close to a transmitter).

– For MW, the set is provided with a built-in aerial, so the telescopic aerial is not needed. Direct the aerial by turning the whole set.

5. To switch off, set the source selector to the TAPE/OFF position (with the cassette keys released).