Troubleshooting

If a fault occurs, first check the points listed below before taking the set for repair.

If you are unable to remedy a problem by following these hints, consult your dealer or service centre.

WARNING: Do not open the set as there is a risk of electric shock. Under no circumstances should you try to repair the set yourself, as this will invalidate the guarantee.

Problem	Solution
CD/VCD OPERATION
"NO" is displayed	– Insert a disc.
	– Check if the disc is inserted upside down.
	– Wait until the moisture condensation at the lens has
	cleared.
	– Replace or clean the disc, see "Maintenance"
	– Use a readable disc or correct recorded format
	MP3-CD.
No picture on TV screen	– Connect the cable between the system and TV.
No colour on TV	– Change the system to the respective PAL or
	NTSC setting.

RADIO RECEPTION
Radio reception is poor	– If the signal is too weak, adjust the antenna
	for better reception.
	– Increase the distance between the Receiver
	and your TV or VCR.

TAPE OPERATION/RECORDING
Recording or playback cannot be made	– Clean deck parts, see "Maintenance".
	– Use only NORMAL (IEC I) tape.
	– Apply a piece of adhesive tape over the missing
	tab space.

GENERAL

English

The system does not react when buttons pressed/set does not work/no display on LCD.

Sound cannot be heard or is of poor quality

–Slide the source sector to TAPE/OFF. Remove and reconnect the AC power plug for 30 seconds and switch on the set again.

–Adjust the volume.

–Make sure the MP3-CD was recorded within

32-320 kbps (128kbps preferably) with sampling frequencies at 8 - 48 kHz (44.1kHz preferably).

The remote control does not function	–	Reduce the distance between the remote control
properly		and the system.
	– Insert the batteries with their polarities (+/- signs)
		aligned as indicated.
	–	Replace the batteries.
	– Point the remote control in the direction of the
		system's IR sensor.