Manuals / Carrier / Household Appliance / Air Conditioner

Carrier 38AH044-084 Ð Dimensions Ð Unit 38AH124, Voltage, Diameter, Quantity, 124A, 124B

Models: 38AH044-084

1 56

Download 56 pages 61.81 Kb

Page 8

DIAMETER

Chart 1, Field Power Supply Connections

	UNIT	VOLTAGE	Hz	DIAMETER		QUANTITY
	38AH	VOLTAGE	Hz	(in.)		QUANTITY
	38AH			(in.)
		208/230	60	35¤8	(92)	1
	124A	460, 575,	60	21¤2	(63)	1
	124B	380	60	21¤2	(63)	1
	124B	380
		346, 380/415	50	35¤8	(92)	1

LEGEND

CÐ Copper Fin Coils MTG Ð Mounting

SAE Ð Society of Automotive Engineers

NOTES:

1. The approximate operating weight of the unit is:

38AH-124---	7260 lb (3293 kg)
38AH-124--C	8126 lb (3686 kg)

2.Unit must have clearances for air¯ow as follows: Top Ð Do not restrict in any way.

Ends Ð 5 ft [1524 mm] Sides Ð 6 ft [1829 mm]

3.Mounting holes may be used to mount unit to concrete pad. They are not rec- ommended for mounting unit to spring isolators.

4.One 35¤8 (92-mm) dia hole is recommended for single-entry power into each module (124A and 124B) of the 208/230-v units.

5.Circled numerals in Top View refer to condenser fans by position.

6.If spring isolators are used, a perimeter support channel between the unit and the isolators is recommended. Do not support each module separately.

7.Each module of the unit must be rigged into position separately. The unit must not be rigged after modules have been connected.

8.Suction and liquid connections can exit on either side of the unit.

9.Field power supply connections are required for each module.

10.See Table 1 for rigging center of gravity (Dimensions K,L,X,Y). See Table 2A and 2B for A-D corner weights.

Fig. 5 Ð Dimensions Ð Unit 38AH124

8

Image 8

Carrier 38AH044-084 specifications Ð Dimensions Ð Unit 38AH124, Voltage, Diameter, Quantity, 124A, 124B

Contents

CONTENTS SAFETY CONSIDERATIONSINSTALLATION Step 5 Ð Install AccessoriesTable 1 Ð Rigging Center of Gravity Ð in. mm Table 2A Ð Operational Corner Weights with Table 2B Ð Operational Corner Weights withStep 2 Ð Check Compressor Mounting Refrigerant Charge Approximate Ð LbFig. 1 Ð Dimensions Ð Units 38AH044,054,064 Chart 1, Field Power Supply ConnectionsFig. 2 Ð Dimensions Ð Units 38AH074,084 Chart 1, Field Power Supply ConnectionsFig. 3 Ð Dimensions Ð Unit 38AH094 UNITVOLTAGE DIAMETER Ð in. mmFig. 4 Ð Dimensions Ð Unit 38AH104 UNITVOLTAGE DIAMETER Ð in. mmFig. 5 Ð Dimensions Ð Unit 38AH124 UNITVOLTAGE DIAMETERFig. 6 Ð Dimensions Ð Unit 38AH134 UNITVOLTAGE DIAMETER Ð38AH 38AH and Sheet Metal Trim Kit and Sheet Metal Trim Unit 38AH134 ShownRIG HERE RIG HERE RIG HEREFig. 9B Ð Field-InstalledSuction Line Loop Fig. 9A Ð Typical Module with CoverPanels Removed Fig. 10 Ð Outer View, Compressor MountingStep 3 Ð Make Refrigerant Piping Connections Table 5 Ð Liquid LiftFig. 13 Ð Double Suction Riser Construction 38AH054-104 Dual-CircuitUnits Ð 60 Hz 38AH054-104 Dual-CircuitUnits Ð 50 Hz Modular Units Dual-CircuitÐ 60 Hz Optional Single-CircuitUnits and 38AH124,134Modular Units Dual-CircuitÐ 60 Hz Modular Units Dual Circuit Ð 50 Hz Modular Units Dual Circuit Ð 50 HzOptional Single-CircuitUnits and 38AH124,134 and 38AH094-134Units Optional Single-CircuitUnitsLEGEND TXV Ð Thermostatic Expansion Valve TYP Ð Typical NOTE Lower split rst on, last offPiping Kit Fig. 16 Ð Units 38AH124 and 134 with InstalledConnect Tubing from Evaporator to Unit Kit Rails Fig. 19 Ð Fully Assembled Piping and Trim KitUnit 38AH134 Shown Cover Unit 38AH134 ShownStep 4 Ð Make Electrical Connections OPTIONAL SINGLE-CIRCUITUNIT UNIT UNIT Table 14 Ð Fan Motor Electrical Data Page Field-supplied 38AH LENGTH Ð FU Ð Fuse FU Ð Fuse Field-supplied NOTES Field-supplied NOTES Field-supplied NOTES System Check Step 5 Ð Install AccessoriesPRE-START-UP Fig. 29 Ð 06E Compressors, Typical START-UPPreliminary Checks Adjust Refrigerant Charge If the initial check shows too much oil too high in the sight glass remove oil to proper level. See Preliminary Oil Charge for proper procedure for adding and removing oil Fig. 30 Ð Charging Chart Ð Unit 38AH044 50/60 Hz Ð Dual Circuit Fig. 32 Ð Charging Chart Ð Unit 38AH064 50/60 Hz Ð Dual Circuit Charging Chart Ð Unit 38AH044 Charging Chart Ð Unit 38AH054Fig. 35 Ð Fig. 36 ÐCharging Chart Ð Unit 38AH064 Charging Chart Ð Unit 38AH074Fig. 39 Ð Charging Chart Ð Unit 38AH084 Fig. 37 ÐFig. 40 Ð Charging Chart Ð Unit 38AH094 50/60 Hz Fig. 41 Ð Charging Chart Ð Unit 38AH104 50/60 HzFig. 42 Ð Charging Chart Ð Modules 124A, 124B Fig. 43 Ð Charging Chart Ð Module 134BSERVICE Refrigerant CircuitCompressor Motor Protection Table 17 Ð Fan Cycling Control Ð Psig kPagCapacity Control Table 18 Ð Pressure Switch Settings Psig kPagFig. 44 Ð Unloader Location and Settings Table 19A Ð One 2-StageThermostat Capacity Control for 38AH044-084 Dual-CircuitUnitsTable 20 Ð One 2-StageThermostat Capacity Control for 38AH094-134UnitsFig. 46 Ð Pressure-ActuatedCapacity Control Valve CONTROLFig. 45 Ð Accumulator and Fusible Plug Fig. 47 Ð Timer Cycle Fig. 49 Ð Condenser Fan Adjustment Fig. 48 Ð Unit Control BoxCompressor Replacement Ð Perform the following TROUBLESHOOTING TROUBLESHOOTING cont START-UPCHECKLIST A. Preliminary InformationB. Pre-Start-Up OUTDOOR UNITC. Start-Up