Installing your USB SuperBooster Dongle

The USB SuperBooster solution has a transmitter unit (sold separately) and a receiver unit. Make certain you install the transmitter unit at your computer or source side. The receiver unit needs to be installed on the device side.

1)Install the Transmitter Wall Plate in a standard J-box where you want your source/computer or connect the Transmitter Dongle to your computer

2)Connect the Receiver Dongle to your device using a standard A/B USB Cable or A/Mini-B USB Cable

3)Use a pre-terminated Cat5/Cat5E/Cat6 cable (recommended) or terminate your own cable using the tool-less RJ45 connectors included to connect the transmitter and receiver together (see below for instructions on terminating your own cable)

4)If using a Transmitter Wall Plate, plug your computer into the transmitter end (USB B side) using a standard A/B USB cable (The green LED will light to indicate you have a good connection to the wall plate)

5)Turn your computer/source on and begin using your device

Terminating a Cat5/Cat5E/Cat6 Cable Using the Tool-less IDC

1)Open the plug by lifting the clear plastic end

2)Pin 1 of the connector is on the left side of the clear plastic shell while Pin 8 is on the right side of the connector (with RJ45 connector facing away from you)

3)Thread the white/orange conductor on your Cat5/5E/6 cable into Pin 1

4)Thread the orange conductor on your Cat5/5E/6 cable into Pin 2

5)Thread the white/green conductor on your Cat5/5E/6 cable into Pin 3

6)Thread the blue conductor on your Cat5/5E/6 cable into Pin 4

7)Thread the white/blue conductor on your Cat5/5E/6 cable into Pin 5

8)Thread the green conductor on your Cat5/5E/6 cable into Pin 6

9)Thread the white/brown conductor on your Cat5/5E/6 cable into Pin 7

10)Thread the brown conductor on your Cat5/5E/6 cable into Pin 8

11)Repeat steps 1-10 to terminate the other end of your Cat5/5E/6 cable

Pin 1

Pin 8