Installing your USB SuperBooster Wall Plate
The USB SuperBooster solution has a transmitter unit (sold separately) and a receiver unit. Make certain you install the transmitter unit at your computer or source side. The receiver unit needs to be installed on the device side.
1)Install the Wall Plate Transmitter in a standard
2)Install the Receiver Wall Plate unit in a standard
3)Use a
4)If using a Wall Plate Transmitter, plug your computer into the transmitter end (USB B side) using a standard A/B USB cable (The green LED will light to indicate you have a good connection to the wall plate) or skip this step if using a Dongle Transmitter as you connected your computer in step 1
5)Plug your device into the receiver end (USB A side) using a standard A/B (or
6)Turn your computer/source on and begin using your device
Terminating a Cat5/Cat5E/Cat6 Cable Using the Tool-less IDC
1)Open the plug by lifting the clear plastic end
2)Pin 1 of the connector is on the left side of the clear plastic shell while Pin 8 is on the right side of the connector (with RJ45 connector facing away from you)
3)Thread the white/orange conductor on your Cat5/5E/6 cable into Pin 1
4)Thread the orange conductor on your Cat5/5E/6 cable into Pin 2
5)Thread the white/green conductor on your Cat5/5E/6 cable into Pin 3
6)Thread the blue conductor on your Cat5/5E/6 cable into Pin 4
7)Thread the white/blue conductor on your Cat5/5E/6 cable into Pin 5
8)Thread the green conductor on your Cat5/5E/6 cable into Pin 6
9)Thread the white/brown conductor on your Cat5/5E/6 cable into Pin 7
10)Thread the brown conductor on your Cat5/5E/6 cable into Pin 8
11)Repeat steps
Pin 1
Pin 8
3