Cables to Go 29570, 29571 manual SOFTWARE/DEVICE Installation

Page 10

SOFTWARE/DEVICE INSTALLATION

IMPORTANT NOTE:

If installing on Windows XP, Service Pack 2 (SP2) is required. Verify that this has been installed before installing the Wireless USB Hub and Adapter Kit software.

Before installing the software, make sure that the Wireless USB Host Adapter and Wireless USB Hub Adapter are not connected to the computer, and the Wireless USB Hub Adapter is not powered.

Step 1-Installing the software

Insert the CD provided and the one of the screens below will appear (depending on which kit you purchased). Select the “Software Installation” from the menu.

9

Image 10
Contents User Guide Table of Contents Introduction Features System Requirements Package Contents Device Overview Wireless USB HUB 4-PORT-29570 Device Overview Wireless USB Device Adapter 1-PORT-29571 SOFTWARE/DEVICE Installation SOFTWARE/DEVICE Installation Figure TruLink Wireless USB Manager Figure Getting Started Screen Figure Successful Install Message Driver Installation for the Wireless USB Hub SOFTWARE/DEVICE Installation Using the Wireless USB KIT Figure Wireless USB Manager IconUsing the Wireless USB KIT Figure Host Settings General Figure Host Settings Advanced Page Technical Specifications QPSK/DCMCables to GO Warranty Statement Important Safety Information There are no User Serviceable PartsFCC Statement Appendix Appendix Cable Association Procedure Appendix Appendix PIN Association Procedure Figure Discovery Mode in Process PIN Change Procedure Appendix Appendix Appendix