Cables to Go 29571, 29570 manual PIN Change Procedure

Page 31

APPENDIX

4.Enter the PIN of the Wireless VGA Adapter (4-digit PIN) and click Accept Association. The Wireless VGA Adapter and Wireless USB Host Adapter are now associated and ready for operation.

PIN CHANGE PROCEDURE

The default PIN setting for the Wireless USB Hub is “1234”. This section gives you the instructions to change the PIN to another 4-Digit value.

IMPORTANT: The application used to change the PIN is not supported in Vista 64bit.

1.Make sure your Wireless USB Host Adapters and the Wireless USB Hub Adapter are not connected to your computer.

2.Open/Launch the application “Pin Update” (C:\Program Files\Wireless USB Manager\Utility\PINUpdate). The following dialog will appear:

30

Image 31

Contents User Guide Table of Contents Introduction Features System Requirements Package Contents Device Overview Wireless USB HUB 4-PORT-29570 Device Overview Wireless USB Device Adapter 1-PORT-29571 SOFTWARE/DEVICE Installation SOFTWARE/DEVICE Installation Figure TruLink Wireless USB Manager Figure Getting Started Screen Figure Successful Install Message Driver Installation for the Wireless USB Hub SOFTWARE/DEVICE Installation Figure Wireless USB Manager Icon Using the Wireless USB KITUsing the Wireless USB KIT Figure Host Settings General Figure Host Settings Advanced Page QPSK/DCM Technical SpecificationsCables to GO Warranty Statement There are no User Serviceable Parts Important Safety InformationFCC Statement Appendix Appendix Cable Association Procedure Appendix Appendix PIN Association Procedure Figure Discovery Mode in Process PIN Change Procedure Appendix Appendix Appendix