Cables to Go 29571, 29570 manual Appendix Cable Association Procedure

Page 27

APPENDIX

CABLE ASSOCIATION PROCEDURE

Cable association steps: Examples/Figures shown used with the association of the TruLink Wireless USB to VGA Adapter

1.Make sure that the Wireless USB Manager is running. Check your Windows tray for the Wireless USB Manager icon (Figure: Wireless USB Manager).

2.Make sure the WIRELESS/WIRED switch is in the WIRELESS position

3.Power on your Wireless USB Device Adapter (TruLink Wireless USB to VGA Adapter).

4.Connect the USB cable between an available USB port on your computer and your Wireless USB Device Adapter.

5.Complete cable association by pressing the “Accept Association” button when prompted. (Figure: Cable Association)

6.Remove the USB cable from your Wireless USB Device Adapter and computer.

Figure: Cable Association

26

Image 27
Contents User Guide Table of Contents Introduction Features System Requirements Package Contents Device Overview Wireless USB HUB 4-PORT-29570 Device Overview Wireless USB Device Adapter 1-PORT-29571 SOFTWARE/DEVICE Installation SOFTWARE/DEVICE Installation Figure TruLink Wireless USB Manager Figure Getting Started Screen Figure Successful Install Message Driver Installation for the Wireless USB Hub SOFTWARE/DEVICE Installation Figure Wireless USB Manager Icon Using the Wireless USB KITUsing the Wireless USB KIT Figure Host Settings General Figure Host Settings Advanced Page QPSK/DCM Technical SpecificationsCables to GO Warranty Statement There are no User Serviceable Parts Important Safety InformationFCC Statement Appendix Appendix Cable Association Procedure Appendix Appendix PIN Association Procedure Figure Discovery Mode in Process PIN Change Procedure Appendix Appendix Appendix