Set Supervisor/User Password |
|
| ||
|
| |||
| CMOS Setup | |||
` | Standard CMOS Features |
| Load | |
` | Advanced BIOS Features |
| Load Optimized Defaults | |
` | Integrated Peripherals |
| Set Supervisor Password | |
` | Power Management Setup |
| Set User Password | |
` | PnP/PCI ConfigurationsEnter Password: | Save & Exit Setup | ||
` | PC Health Status |
| Exit Without Saving | |
` | MB Intelligent Tweaker(M.I.T.) |
|
|
|
ESC: Quit | KLJI: Select Item |
| F11: Save CMOS to BIOS | |
F8: | F10: Save & Exit Setup | F12: Load CMOS from BIOS | ||
|
| Change/Set/Disable Password |
| |
|
|
|
|
|
Press <Enter> on this item and type the password with up to 8 characters and then press <Enter>. You will be requested to confirm the password. Type the password again and press <Enter>.
The BIOS Setup program allows you to specify two separate passwords:
Supervisor Password
When a system password is set and the Password Check item in Advanced BIOS Features is set to Setup, you must enter the supervisor password for entering BIOS Setup and making BIOS changes.
When the Password Check item is set to System, you must enter the supervisor password (or user password) at system startup and when entering BIOS Setup.
User Password
When the Password Check item is set to System, you must enter the supervisor password (or user password) at system startup to continue system boot. In BIOS Setup, you must enter the supervisor password if you wish to make changes to BIOS settings. The user password only allows you to view the BIOS settings but not to make changes.
To clear the password, press <Enter> on the password item and when requested for the password, press <Enter> again. The message "PASSWORD DISABLED" will appear, indicating the password has been cancelled.
- 51 - | BIOS Setup |