Date (mm:dd:yy)
Sets the system date.
Time (hh:mm:ss)
Sets the system time.
IDE Channel 0, 1, 2, 3 Master
IDE HDD
Press <Enter> to autodetect the parameters of the SATA device on this channel. 
IDE Channel 0, 1 Master, Extended IDE Drive
Configure your SATA devices by using one of the three methods below:
• Auto | Lets the BIOS automatically detect SATA devices during the POST. (Default) |
• None | If no SATA devices are used, set this item to None so the system will skip the |
| detection of the device during the POST for faster system startup. |
• Manual | Allows you to manually enter the specifications of the hard drive when the hard drive |
| access mode is set to CHS. (For IDE Channel 0, 1 Master only.) |
Access Mode | Sets the hard drive access mode. (Default: Auto) |
The following fields display your hard drive specifications. If you wish to enter the parameters manually, refer to the information on the hard drive.
Capacity | Approximate capacity of the currently installed hard drive. |
Cylinder | Number of cylinders. |
Head | Number of heads. |
Precomp | Write precompensation cylinder. |
Landing Zone | Landing zone. |
Sector | Number of sectors. |
Halt On
Allows you to determine whether the system will stop for an error during the POST.
Options are: "All Errors," "No Errors," "All, But Keyboard" (default), "All, But Diskette," "All, But Disk/Key."
Memory
These fields are
BIOS Setup | - 24 - |