Gigabyte GA-M61PME-S2P user manual Back Panel Connectors

Page 18

1-6 Back Panel Connectors

PS/2 Keyboard and PS/2 Mouse Port

Use the upper port (green) to connect a PS/2 mouse and the lower port (purple) to connect a PS/2 keyboard.

Parallel Port

Use the parallel port to connect devices such as a printer, scanner and etc. The parallel port is also called a printer port.

Serial Port

Use the serial port to connect devices such as a mouse, modem or other peripherals.

D-Sub Port

The D-Sub port supports a 15-pin D-Sub connector. Connect a monitor that supports D-Sub connection to this port.

USB Port

The USB port supports the USB 2.0/1.1 specification. Use this port for USB devices such as an USB keyboard/mouse, USB printer, USB flash drive and etc.

RJ-45 LAN Port

The Fast Ethernet LAN port provides Internet connection at up to 100 Mbps data rate. The following describes the states of the LAN port LEDs.

Connection/

 

 

 

 

 

 

 

 

 

 

Speed LED

 

 

 

Activity LED

Connection/Speed LED:

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

State

Description

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Green

100 Mbps data rate

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Off

10 Mbps data rate

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

LAN Port

Activity LED:

State

Description

Blinking

Data transmission or receiving is occurring

Off

No data transmission or receiving is occurring

When removing the cable connected to a back panel connector, first remove the cable

from your device and then remove it from the motherboard.

When removing the cable, pull it straight out from the connector. Do not rock it side to side to prevent an electrical short inside the cable connector.

GA-M61PME-S2P Motherboard

- 18 -

Image 18
Contents GA-M61PME-S2P Motherboard Documentation Classifications CopyrightDisclaimer Identifying Your Motherboard RevisionTable of Contents Drivers Installation Box Contents GA-M61PME-S2P Motherboard Layout Block Diagram Hardware Installation Installation PrecautionsProduct Specifications USBBios Installing the CPU and CPU Cooler Installing the CPUCPU Socket Locking Lever Installing the CPU Cooler Installing the Memory Dual Channel Memory ConfigurationInstalling a Memory Installing an Expansion Card Back Panel Connectors Line In Jack Blue Line Out Jack GreenMic In Jack Pink Internal Connectors SATA20 / SATA21GND FDD Floppy Disk Drive Connector CPUFAN/SYSFAN Fan HeadersIDE IDE Connector SATA20/SATA21 Sata 3Gb/s ConnectorsPwrled System Power LED Header BAT BatteryPW Power Switch, Red Fpanel Front Panel HeaderFaudio Front Panel Audio Header Hdasur Surround/Center Audio HeaderCdin CD In Connector Spdifio S/PDIF Out HeaderFUSB1/FUSB2 USB Headers CI Chassis Intrusion HeaderClrcmos Clearing Cmos Jumper GA-M61PME-S2P Motherboard Bios Setup F12 Boot Menu Function Keys DEL Bios SetupF9 Xpress Recovery2 Startup ScreenMain Menu Sample Bios Version E8Bios Setup Program Function Keys Main Menu Help Power Management Setup  Standard Cmos Features Advanced Bios Features  PnP/PCI ConfigurationsIDE Channel 0 Master/Slave DateTime IDE Channel 2/3 MasterHalt On Floppy 3 Mode SupportDrive a MemoryVirtualization Hard Disk Boot PriorityFirst/Second/Third Boot Device Patch AMD TLB Erratum NoteHDD S.M.A.R.T. Capability Password CheckAway Mode Init Display FirstOn-Chip IDE Channel IDE Prefetch ModeSerial-ATA RAID Config NV Sata ControllerECP Mode Use DMA Onboard LAN Boot ROMParallel Port Mode NV Sata RAID functionUSB Keyboard Support USB Mouse SupportLegacy USB storage detect PME Event Wake Up Modem Ring OnPower On By Mouse Power-On by AlarmHpet Mode Note Power On By KeyboardPnP/PCI Configurations PCI 1 IRQ AssignmentPCI 2 IRQ Assignment System/CPU Warning Temperature Reset Case Open StatusCurrent System/CPU Temperature Case OpenedCPU Smart FAN Mode Load Fail-Safe Defaults Load Optimized DefaultsSupervisor Password User PasswordSave & Exit Setup Exit Without SavingGA-M61PME-S2P Motherboard Drivers Installation Installing Chipset DriversApplication Software Technical ManualsContact SystemDownload Center Installing Windows Vista and Partitioning the Hard Drive Xpress Recovery2Installation and Configuration Before You BeginAccessing Xpress Recovery2 Using the Backup Function in Xpress Recovery2Using the Restore Function in Xpress Recovery2 Removing the BackupExiting Xpress Recovery2 What is DualBIOSTM? Bios Update UtilitiesUpdating the Bios with the Q-Flash Utility What is Q-FlashTM?Updating the Bios Page Save the Current Bios File Updating the Bios with the @BIOS UtilityInstalling and Using @BIOS Update the Bios Using the Internet Update FunctionUpdate the Bios without Using the Internet Update Function Click Update New BiosEasyTune EasyTune 5 Interface Button Information TableGA-M61PME-S2P Motherboard To configure Sata hard drives, follow the steps below Configuring Sata Hard DrivesConfiguring the Onboard Sata Controller Installing Sata hard drives in your computerConfiguring Sata controller mode in Bios Setup Configuring RAID set in RAID Bios AppendixYES Nvidia Required for RAID Mode Making a Sata RAID Driver Diskette for Windows XPAppendix Rebuilding an Array Healthy Manually rebuilding a hard driveUnder Storage in the Select a Task pane Configuring Audio Input and Output Configuring 2/4/5.1/7.1-Channel AudioInstalling the 5.1/7.1 Surround Cable Configuring Speakers Audio JacksHigh Definition Audio HD Audio Configuring Sound Effect Activating an AC97 Front Panel Audio ModuleMuting the Back Panel Audio For HD Audio Only Pdif Configuring S/PDIF In/OutInstalling the S/PDIF In and Out Cable Pdif outConfiguring S/PDIF In and Out Configuring S/PDIFConfiguring S/PDIF Out Configuring Microphone Recording Enabling Stereo Mix Using the Sound Recorder Recording SoundPlaying the Recorded Sound Troubleshooting Frequently Asked QuestionsTroubleshooting Procedure StartEND Regulatory Notices Weee Symbol StatementRegulatory Statements Our Commitment to Preserving the EnvironmentChina Restriction of Hazardous Substances Table GA-M61PME-S2P Motherboard Contact Us  G.B.T. INC USA Mexico Gigabyte Global Service System