Freecom Technologies Network hard drive specs

Freecom Classic SL Network Drive

Msconfig can be accessed by clicking on Start-> Run-> and typing in "msconfig" and clicking OK.

For further help, please contact the Freecom Support Center for your country.

10.When adding Classic SL Network Drive to my computer, why does the "ADD" button stay gray?

You may not have entered all the alpha-numeric values correctly. There are no letter "O"s; please verify that you have used the number "0" (zero) for anything resembling an "O." Also please check by our other letters as well; two V’s may look like a W. Start by entering only the Classic SL Network Drive ID. The ADD button should not be greyed out if the correct ID is entered. Once it is not greyed out, proceed to add the Write Key as well.

Please also make sure that there are 20 characters for the Classic SL Network Drive ID, not including the Write Key.

11.I installed the Classic SL Network Drive key but cannot see Classic SL Network Drive in "My Computer." What should I do?

Click on the Classic SL Network Drive Admin Tool in your System tray and make sure Classic SL Network Drive is enabled. There should be a dot next to your Classic SL Network Drive, colored either Blue (Read/Write) or Green (Read Only). If it is a black colored dot, then please go to the FAQ: "I’ve installed my Classic SL Network Drive and it shows up as a Black Dot."

If Classic SL Network Drive is enabled, open "Computer Management" by right -clicking on "My Computer." Go to "Manage," then click on "Disk Management." Check if your Classic SL Network Drive is recognized. It should show up as Disk 1 or Disk 2 or a different number depending on the number of drives that you have on your computer. Right -click on the appropriate "Disk #" and click "Initialize." if that option exists.

Also make sure that the Classic SL Network Drive is partitioned and format- ted. If you see something that says "Unallocated," then right-click on the "Unallocated," create a partition, and then format the drive to your file system preference.

To use Classic SL Network Drive with other Operating Systems such as Windows 98SE / ME, and Mac OS X, you will need to format your Classic SL Network Drive to FAT32 for it to be recognized.

12.Why am I getting a "Data has been corrupted" message when I try to open or copy a file?

Open up Command Prompt and run "chkdsk" for the Classic SL Network Drive drive.

Go to Start - Run - type in "cmd" without the quotation marks. Then type in "chkdsk Classic SL Network Drive DriveLetter: /F"

For example, if your Classic SL Network Drive shows up as drive letter E: in

My Computer, you would type in the following: chkdsk E: /F