ADDONICS TECHNOLOGIES
Model: RT5835HMEU
Instruction for Special RAID Modes:
BIG 2 - 2 Drives Spanned
oNote: Do not connect more than 2 SATA drives to the hardware port multiplier. Doing so will hang the system when you configure the raid.
oFor SATA drives with different capacities, the hardware port multiplier will use the smallest drive capacity of the 2 drives connected to create the total partition size.
FAST 2 - 2 Drives Striped
oNote: Do not connect more than 2 SATA drives to the hardware port multiplier. Doing so will hang the system when you configure the raid.
Verify RAID Setting on the HPM
Note: Disconnect the HPM from host when verifying the RAID setting.
It is assumed that you have already connected the SATA drives and set up the raid mode when verifying the raid setting.
1.Turn on the power for RAID tower mini.
2.Push the RAID setting button with the tool provided. Using the table below, verify if the LEDs are lighting up. The selected LEDs will light up for 2 seconds followed by a blink and cycles back.
|
| RAID Mode | LEDs |
|
|
|
|
|
| BIG 2 | LEDs 1, 2 & 3 all OFF |
|
| BIG 4 | 3 ON, 2 & 1 OFF |
|
| FAST 2 | 2 ON, 3 & 1 OFF |
|
| FAST 4 | 1 ON, 3 & 2 OFF |
|
| SAFE FAST | 3 & 2 ON, 1 OFF |
|
| SAFE 2 | 3 & 1 ON, 2 OFF |
|
| RAID 5 | 2 & 1 ON, 3 OFF |
|
| RAID 5 + S | 3, 2 & 1 all ON |
LED reference: |
| ||
LED 1 | - HPM Health |
| |
LED 2 | - eSATA Status |
| |
LED 3 | - USB Status |
| |
TECHNICAL SUPPORT
Phone: | |
Hours: | 8:30 am - 6:00 pm PST |
Email: | http://www.addonics.com/support/query/ |