Addonics Technologies Z4SNHU3 manual RAID Setting Notes

RAID Setting Notes:

	RAID 1& RAID 10 Mode							When 2 drives are
								connected to the HPM-XU,
SW1								and DIP switch is set to this
								setting, the 2 drives will be
		1	2				5
					3	4		configured as a 2-drive
		BZS EZ			M2 M1 M0			RAID1 array.
When 4 drives are connected to the HPM-XU, the 4 drives will be
configured as a 4-drive RAID10 array.
			Clone Mode					Clone’s action is similar to
								RAID1. However, all of the
SW1								hard drives will be mirrored.
								Clone mode is useful
		1	2	3				especially when users like
						4	5
								to copy data from a source
		BZS EZ			M2 M1 M0
								hard drive to the drives

connected to the HPM-XU.

f.Press the RAID setting button with a ball point pen.

g.While pressing the RAID setting button turn on the system power where the HPM is connected. The buzzer will sound while holding the RAID setting button. Release it after at least 5 seconds for hardware initialization. A single beep will be heard to indicate initialization is completed.

h.Verify if the RAID array is detected by the system.

i.If the 5-port HPM-XU is connected to the motherboard onboard SATA, on the CMOS setup utility, the raid array will display as “Addonics H/W RAID5” if setup as a RAID5 array.

j.If the 5-port HPM-XU is connected to an eSATA host controller card, on the RAID BIOS, the raid array will display as “Addonics H/W RAID0” if setup as a RAID0 array.

k.If booted into Windows, in Disk Drives under Device Manager, the raid array will display as “Addonics H/W LARGE” if setup as a LARGE array.

l.Once raid array is verified, you can set the buzzer either ON or OFF.

www.addonics.com

Technical Support (M-F 8:30am - 6:00pm PST) Phone: 408-453-6212 Email: www.addonics.com/support/query/