xp CDR 775/00.1 english
Fixing problems
| TIP: |
| Check ‘Display messages’: the nature of a problem will in most cases be |
| indicated with a display message. |
| WARNING |
| Under no circumstances should you try to repair the CD recorder |
| yourself as this will invalidate the guarantee. |
| Do not open the CD recorder as there is a risk of electric shock. |
| If a fault occurs, first check the points listed, before taking the CD |
| recorder for repair. If you are unable to solve a problem by following |
| these hints, consult your dealer or service centre. |
| Laser safety |
| This unit employs a laser. Only a qualified service person should remove |
| the cover or attempt to service this device, due to possible eye injury. |
|
|
Problem | Solution |
No power | – ensure that the ON/OFF key is in the on position (red LED on): the CD |
| recorder is in standby mode, press any key to activate it |
| – make sure that the power cable is plugged in correctly |
| – switch the recorder OFF and then immediately back ON |
No sound | – check the audio connections (external recording) |
| – try using a different source on the amplifier |
| – make sure the record level was correctly adjusted |
| – check if the right deck was selected |
Amplifier sound is distorted | – make sure that the CD recorder analog output is not connected to the |
| amplifier Phono input |
Play will not start | – make sure that the label of the CD is facing up |
| – clean the disc |
| – make sure that the disc is not defective by trying another disc |
| – check if the right deck was selected (in DJ mode) |
| – finalize the disc first before playing it in the CD player deck |
Remote control does not work | – press CDR on the remote control and try again |
| – point the remote control directly at the CD recorder |
| – check the batteries and replace if necessary |
| – select the right source first |
Will not record | – clean the disc |
| – check if CDR(W) is an unfinalized disc (INITIALIZING is diplayed when |
| disc is unfinalized) |
| – check that the disc is recordable and replace if necessary |
| – the disc is not an AUDIO disc (WRONG DISC) |
| – wrong input source chosen. Input label flashing (CHECK INPUT) |
| – try using a Philips Audio CDR(W) |
Recording is distorted | – make sure the recording level is correctly adjusted |
Recorder does not react | – switch the ON/OFF button on the front of the recorder off and back on |
DISC RECOVER on display | – a power failure has occurred during recording; the CD recorder is attempting |
| to repair the disc |
DISC ERROR appears on the display | – the disc cannot be recorded further, and cannot be finalized. |
| – on a CDRW disc, the track being recorded is lost, but further recording and |
| finalization can still be done |
Recorded tracks do not start or stop | – check if there are at least 2.7 seconds silence in between the tracks |
at the correct time or tracks have | (analog recording only) |
been merged together | – insert track increments manually with the remote control (during recording) |
START SOURCE indication | – start the synchronized external recording by pressing PLAY on the external |
| source you wish to record from |
| – check the connections |
| – press STOP 9, select REC EXT MAN and start the recording manually |
| – select the right input with the SOURCE key |
30