Mounting, Horizontal Mount | Tripp Lite TMU Series specs

Mounting

WARNING! Mount your UPS System BEFORE DC battery and AC power connection. Failure to follow these instructions may lead to personal injury and/or damage to the UPS System and connected systems.

Tripp Lite manufactures a variety of UPS Systems with a variety of mounting options. Tripp Lite recommends permanent mounting of your UPS System in any of the configurations illustrated below. User must supply mounting hardware and is responsible for determining if the hard- ware and mounting surface are suitable to support the weight of the UPS System. Contact Tripp Lite if you require further assistance in mounting your UPS System.

Horizontal Mount

(612 & 1250 models only)

AUsing the measurements from the diagram, install two user-sup- plied ¼" (6 mm) fasteners into a rigid horizontal surface, leaving the heads slightly raised. B Slide the UPS System back over the fasteners to engage the mounting slots molded on the bottom of the UPS System cabinet. C Install and tighten two user-supplied ¼" (6 mm) fasteners into the mounting feet molded on the front of the UPS System cabinet.

4.5 in.

(11.4 cm)

6.75 in.

(17.1 cm)

	6.75 in.
7.87 in.	(17.1 cm)
7.87 in.
(20 cm)

Horizontal Mount

(1012 and 2012 models only)

AUsing the measurements from the diagram, install two user-sup- plied ¼" (6 mm) fasteners into a rigid horizontal surface, leaving the heads slightly raised. B Slide the UPS System forward over the fasteners to engage the mounting feet molded on the front of the UPS System cabinet. Install and tighten additional user-sup- plied ¼" (6 mm) fasteners into the mounting feet molded on the rear and sides of the UPS System cabinet*. The rear feet extend beyond the unit’s cabinet to provide for adequate ventilation space behind the cooling fan(s); they should not be removed.

			5.57 in.
			(14.16 cm.)
			9.59 in.
		B	(24.35 cm.)
		B
	9.59 in.		5.87 in.
	(24.35 cm.)		(14.91 cm.)
	5.57 in.		5.87 in.
	5.57 in.		5.87 in.
A	(14.16 cm.)		(14.91 cm.)
A

1.64 in.

(4.15 cm.)

Note: Cabinets may have different front panel features, but all mount as per the figure above, or via the Lateral Mounting Bracket, illustrated at left.

* All models include front and rear mounting feet. Select models include side mounting feet.