Troubleshooting
The UPS’s control panel lights will turn on in the sequences below to signal that the UPS is having operational difficulties.
Lights (On/Flashing) and Condition | Solution |
On: REPLACE BATT | Let the UPS system charge for at least |
Condition: Replace Battery | 12 hours and perform a self test using |
| the "ON/Test Switch" as described on |
| page 7. If the light continues to stay on, |
| contact Tripp Lite for service. |
|
|
On: BATT LOW, ON BATT | Prepare for imminent UPS shutdown. |
Condition: Battery Low |
|
|
|
On: BYPASS, LINE, LOAD, OVERLOAD | Reduce the load the UPS supports. |
Condition: On Bypass due to Overload |
|
|
|
Flashing: OVERLOAD | Remove the cause of the short circuit |
Condition: Short Circuit | from the UPS output. |
|
|
On: FAULT | Check the utility line for wiring problems |
Condition: Wiring Fault | such as reversed line and neutral or a |
| missing ground. |
|
|
On: FAULT, 100% | Restart the UPS. If the problem persists, |
Condition: Battery Voltage too High | contact Tripp Lite for repairs. |
|
|
On: FAULT, BYPASS, LINE, 50% | Restart the UPS. If the problem persists, |
Condition: On Bypass due to | contact Tripp Lite for repairs. |
High Output Voltage |
|
|
|
On: FAULT, BYPASS, LINE | Restart the UPS. If the problem persists, |
Flashing: 50% | contact Tripp Lite for repairs. |
Condition: On Bypass due to |
|
Low Output Voltage |
|
|
|
On: FAULT, BYPASS, LINE, 25%
Condition: On Bypass due to High Bus Voltage
Restart the UPS. If the problem persists, contact Tripp Lite for repairs.
On: FAULT, BYPASS, LINE
Flashing: 25%
Condition: On Bypass due to Low Bus Voltage
Restart the UPS. If the problem persists, contact Tripp Lite for repairs.
11