Tripp Lite Quick Installation, Turn your UPSs power, Switch on, Optional All models

Quick Installation

1

2

Plug your UPS into an electrical outlet.

Plug your computer, monitor and external modem into battery- supported outlets.

Plug other equipment into surge-only outlets of your UPS.*

Optional (All models)**

Using telephone cords, connect your wall jack to the UPS jack marked “LINE” (or “IN”). Connect your equipment to UPS jack marked “EQUIP” (or “OUT”).

Optional (Select models)**

Using Tripp Lite cable (if supplied), connect the DB9 port of your computer to the DB9 port of your UPS. Load software (if supplied) and run installation program appropriate to your operating system.

3	Turn your UPS's power
	switch ON.

*Identified on the back of your UPS. Your UPS is designed to support only computer equipment. You will overload your UPS if you connect household appliances, laser printers or surge suppressors to the battery-supported outlets. **Phone line and DB9 port connections are optional. Your UPS will function properly without these connections. Make sure the equipment you connect to the UPS’s telephone jacks is also protected against damaging surges on the AC line.

3