Tripp Lite HCRK-INT owner manual Turn the Power Supply Module’s Outlet on

Connection / Start-Up continued

5Turn the Power Supply Module’s Outlet ON

Press and hold the “Power” button* for one second. The alarm will beep once briefly after one second has passed. Release the button. The “Power” LED* will illuminate to indicate that the Power Supply Module’s outlet is ON. The Battery Charge LED Meter* will indicate the approximate charge level of the connected Battery Module.

* Located on the Remote User Interface (RUI).

5

6 Plug Your AC Equipment into
the Power Supply Module’s
Outlet
The Power Supply Module provides filtered,
pure sine-wave 230V AC power for a variety of
equipment—computers, monitors, diagnostic
devices, scanners and more. You will overload
the Power Supply Module if the total VA ratings
for all the equipment you connect exceeds	6
350VA (the Power Supply Module’s continuous
output capacity).*

*To find your equipment’s VA ratings, look on their nameplates. If the equipment is listed in amps, multiply the number of amps by 230 to determine VA. (Example: 1 amp x 230 = 230VA).

7	OPTIONAL—Install PowerAlert
	Data-Saving Software
	This connection is optional. The Power
	Supply Module and Battery Module will
	function properly without this connection.
	Using the included cable*, connect the
	Power Supply Module’s USB port to the
	USB port on any laptop or desktop
	computer mounted on the mobile cart.	7
	Insert the included PowerAlert CD and load
	the version of PowerAlert appropriate for
	the computer’s operating system. Follow
	the setup and configuration screens for your
	specific application. PowerAlert documentation
	is also included on the CD.

*If desired, you can substitute a standard USB cable in place of the included cable.

8