Mounting the Bracket on a Wall

1111 W. 35th Street

Chicago, IL 60609 USA

Customer Support: (773) 869-1234

www.tripplite.com

A B C D

Mounting Instructions

Wallmount

Bracket

for the SmartPro® 1400XL NET,

BP-36V27 and SNMP Solo

ESPAÑOL: p. 2 FRANÇAIS: p. 2

Hold the Bracket level against the intended mount- ing surface and mark the locations of the mounting holes (A). Drill 1/8” guide holes in these locations. Place the included wash- ers around the included screws, then drive the screws through the mount- ing holes and into the guide holes.

CAUTION: The hardware (screws and washers) in- cluded with the Bracket is only intended for use with plywood surfaces. To mount your Bracket on a different surface, you must determine a safe mounting procedure and obtain proper hardware.

Mounting a SmartPro or Battery Pack

CAUTION: Before mounting a SmartPro UPS, make sure the UPS is OFF and un- plugged. Before mounting a BP-36V27 battery pack, make sure that the battery pack is disconnected from your SmartPro system. The UPS or battery pack is ex- tremely heavy. Take care to avoid injury while lifting.

Place the UPS or battery pack in the mounting tray. The feet of a UPS should press against the rear ridge

(B)and fit around the center ridge (C) while the front of the UPS presses against the front ridge (D). The base of a battery pack should fit between the rear (B) and center (C) ridges, with its cords facing the wall.

Next, Pass the safety strap around the UPS or battery pack and through the mounting tray as shown. The safety strap should pass through the tray’s outer strap holes for a UPS or through the tray’s inner strap holes for a battery pack. Fully tighten the safety strap and fasten the velcro end.

Mounting a SNMP Solo

Affix one of the self-adhe- sive velcro pads included in the bottom of the bracket’s SNMP slot (E). Affix the other pad to the long side of the SMMP-Solo opposite its indicator lights. Press the velcro-covered side of the SNMP-Solo into the bracket’s SNMP slot.