Installation Instructions

Note: Test to make sure that the entire installation works properly before pulling cables through ceilings or walls.

1.Before connecting the B203-104 local unit to the computer, locate the driver file on the included CD and double-click on it to start the installation process.

2.Follow the installation prompts, choosing to “proceed anyway” when prompted if the driver is from a trusted source. At the end of the installation, you will be prompted to restart the computer. Click yes to proceed.

3.After the computer has restarted, connect the B203-104 local unit to an available USB 2.0 port on the computer using the included USB A/B cable. Upon connecting the local unit, the red power LED will illuminate, and the driver will finish installing.

Note: USB LAN Extender software will be installed on your computer, with a Launch USB 2.0 Extender shortcut icon placed on your computer desktop, and a USB 2.0 Extender icon displayed in the lower-right corner of your computer screen. (See the USB LAN Extender Software section below for details.)

4.Connect the RJ45 ports on the local and remote units using Cat5e/6 cabling.

5.Connect the external power supply to the remote unit, and plug it into a Tripp Lite

Surge Suppressor, Power Distribution Unit (PDU), or Uninterruptible Power Supply (UPS). The green power LED will illuminate. In addition, the USB LAN Extender software will recognize that the B203-104 units are connected, and the icon in the lower-right corner will turn from blue with a red circle on it, to a blue icon.

6.Connect your USB devices to the remote unit. The orange LED next to each USB port will illuminate when a device is connected. The USB 2.0 Extender icon in the lower-right corner will turn from blue to green when the device is recognized. It may take a few seconds for the device to be recognized.

201206181-93-3167.indb 4

7/9/2012 4:19:09 PM