Moxa Technologies EDS-508 manual Step

Installing MOXA EtherDevice Switch

STEP 2:

Mounting MOXA EDS-508 on the wall requires 4 screws. Use the EDS-508, with wall mount

plates attached, as a guide to mark the correct locations of the 4 screws. The heads of the screws should be less than 6.0 mm in diameter, and the shafts

should be less than 3.5 mm in diameter, as shown in the figure at the right.

NOTE Before tightening screws into the wall, make sure the screw head and shank size are suitable by inserting the screw into one of the keyhole -shaped apertures of the Wall Mounting Plates.

Do not screw the screws in all the way— leave about 2 mm to allow room for sliding the wall mount panel between the wall and the screws.

STEP 3: Once the screws are fixed in the wall, insert the four screw heads through the large parts of the keyhole-shaped apertures, and then slide EDS-508 downwards, as indicated below. Tighten the four screws for more stability.

MOXA EtherDevice Switch Hardware Installation Guide 2-5