StarTech.com SV431D, SV830 Initial Power-Up, Replace Master Console Devices, Adhesive Rubber Foot

8

Initial Power-Up

Make sure all computers and StarViews are powered down during installation. You must power up the Master StarView before turning on any other devices.

￿For single StarView: 1) Apply a power adapter to the Master.

2)Turn on computers.

￿For cascade: 1) Apply a power adapter to the Master.

2)Apply power adapters to all Slaves. 3) Turn on computers.

Note: You may hot plug additional powered-down computer and Slave without turning any existing StarView or computer off after initial power up.

Replace Master Console Devices

You can replace a faulty keyboard or mouse of the Master CONSOLE port at any time without powering down the Master, as long as your computers are booted with proper device driver for the new device. Should you encounter any difficulty, just activate K/M RESET by holding both front-panel ‘1’ and ‘2’ push buttons down for 2 seconds.

Adhesive Rubber Foot

For desktop operation, you may stick the four round rubber feet (supplied with the unit) to the bottom of the StarView. NOTE: Do not use the rubber feet for rack mount operation.