StarTech.com CABCONS1716I manual Stty -crtscts /dev/serial port

Operating Notes:

•If the power supply to the R-Port modules you have connected becomes faulty (short, overload) then the R-Port LED on the front panel of the CABCONS1716I will show red.

•Under normal operations, this light should remain green. The R-Port connector on the rear panel also has an LED that mirrors the status of the light on the front panel.

•Hardware handshaking (CTS/RTS) is required for speeds exceeding 9600 bps. It is enabled by default on the CABCONS1716I, but may need to be enabled on the other end of the connection. For Unix systems, the command is:

stty –crtscts < /dev/[serial port]

•A maximum of four users may simultaneously login to the same module. All users may type commands at any time, and all users will see the same output.

NOTE:

•All users have equal access to all channels.

•A maximum of 16 R-Port modules may be connected at any one time.

•You can plug-in or unplug any R-Port module at any time.

When reconnected, it will automatically become available after a 15 second initialization period. Any log entries will be retained by the R-Port module while deactivated, but will not be available to users until it is re-initialized.

Instruction Manual

53