Q-Logic FIRMWARE VERSION 7.4 manual A1007.000B Security Efmd Rejected, bad revision

A

3 – Event Messages Alarm Events

(A1007.0008) (Security: ESA Response failure, failing security checks)

Meaning:	A failure was received during processing of the ESA received
	frame. Either the payload did not match the standard layout or the
	payload status indicated a reject.
Action:	Check for errors on the remote side of the link. Check the
	transceiver and cable. Update firmware on the remote switch.

(A1007.0009) (Security checks EFMD response failure, failing security check.)

Meaning:	A remote switch rejected a Exchange Fabric Membership Data
	(EFMD) frame. The port will be isolated.
Action:	Check remote switch for the reason that the EFMD frame was
	rejected. It is possible that the FabricBindingEnabled parameter is
	different on the two switches.

(A1007.000A) (Security: Dropping lock held by domain domain_id for number seconds)

Meaning:	A remote switch has held the fabric lock for too long. The local
	switch is dropping the lock in order to send out a Exchange Fabric
	Membership Data (EFMD) frame.
Action:	None
(A1007.000B) (Security: EFMD Rejected, bad revision)
Meaning:	The remote switch is running at a different Exchange Fabric
	Membership Data (EFMD) version level than the local switch. Ports
	will isolate.
Action:	None
(A1007.000C) (Security policy restrict mode, security db differs)
Meaning:	The current security policy calls for Restrict Mode, which means
	that all switches in the fabric must have the same security
	databases or the inter-switch links will not log in. In this case, the
	security databases differ.
Action:	Reconfigure the active security set so that the ISL group members
	are the same.

(A1007.000D) (Security policy in mode mode, other switch in mode mode, sec db conflict)

Meaning:	The security policy on the local switch differs from that of the
	remote switch.
Action:	Configure the security policy on the remote switch to match that of
	the local switch.

59060-05 A 3-33