
Q
2 – QLA2310F/2310FL Specifications
2.2.1
Installation Help
If your system has an IDE hard disk, it may be assigned device number 80, which is the boot device. If your system does not have an IDE hard disk, a parallel SCSI host bus adapter (HBA), or a RAID adapter, the first bootable FC hard disk configured (the one with the lowest ID) is assigned device number 80 and becomes the boot device. The QLA2310F/2310FL HBA BIOS must be enabled if the boot device is connected to the QLA2310F/2310FL HBA.
If you have a selectable boot BIOS and want to boot to an FC hard disk, set the motherboard BIOS parameters to None or Not Installed. The ROM BIOS on the QLA2310F/2310FL HBA automatically configures the FC peripherals.
Some new system BIOSs support selectable boot, which supersedes the QLA2310F/2310FL HBA BIOS selectable boot setting. Select the QLA2310F/2310FL HBA FC hard disk in the system BIOS to boot from an FC hard disk attached to the QLA2310F/2310FL HBA.
2.3
Specifications
Tables
Table 2-1. QLA2310F/2310FL Board Operating Environment
Environment | Minimum | Maximum |
|
|
|
Operating temperature | 0°C/32°F | 55°C/131°F |
Storage temperature | 70°C/158°F | |
Relative humidity (noncondensing) | 10% | 90% |
Storage humidity (noncondensing) | 5% | 95% |
|
|
|
Table 2-2. QLA2310F/2310FL Board Specifications
Type |
| Specification |
|
| |
Host bus | Conforms to PCI Local Bus Specification, revision 2.2 and the | |
|
| |
3.3 V and 5.0 V buses supported | ||
environment |
|
|
132 | MBps maximum burst rate for | |
rate | 264 | MBps maximum burst rate for |
| 66 MHz | |
| 264 | MBps maximum burst rate for |
| 528 | MBps maximum burst rate for |
| 66 MHz | |
|
|
|