Moxa Technologies user manual 24 CA-132/132I User’s Manual

3.You have to configure the Port No., I/O Address, IRQ and INT Vector properly. These settings MUST match up the hardware configuration of CA-132 or CA-132I.

4.You may press PgDn key to have advanced “Port setup”. Now the configuration of the desired CA-132 Series board will be shown along with other default settings, such as port number, buffer size, etc.

Up to now you have completed the setup for CA-132Series board. You may skip this step and go directly to the next step 4 if you need not change any setting or configure any board.

You may now enter/modify each port’s configuration. These displayed values are the port initial values as driver is loaded.

Legend: Some noticeable fields and functions are explained below.

3-24 CA-132/132I User’s Manual