Equipment Placement and Rack Mounting
The NSM5200 can be placed on a flat surface, such as a desktop, or mounted in an equipment rack.
DESKTOP INSTALLATION
WARNING: Do not place the NSM5200 on its side; in this position, the unit is likely to fall over and may cause equipment damage or personal injury.
To install the NSM5200 on a desktop:
1.Make sure the rubber feet are installed to prevent surface damage. If not, secure each rubber foot to the bottom panel of the unit (refer to Figure 5). Use the five
2.Remove the two chassis brackets from the sides of the unit, if they are attached. Remove the
3.Position the unit to allow for cable and power cord clearance at the rear of the unit.
REMOVE BRACKETS
AND SCREWS
Figure 5. Installing Rubber Feet and Removing Brackets
C3683M (3/09) | 13 |