Pelco ips-rdpe-2 manual Cable/Wire Requirements and Connector Locations

Page 8

Cable/Wire Requirements and Connector Locations

Refer to Figure 3 for a layout of the data port box connectors.

It is important to connect all four communication wires from the IPS-RDPE-2 to the Spectra dome system or ExSite system. It will not be possible to perform software and language file uploads if the transmit and receive wires are not connected.

OPTIONAL

=POSITIONING

SYSTEM

CONNECTIONS

Figure 3. IPS-RDPE-2 Connections

NOTES:

Input power for the IPS-RDPE-2 is 24 VAC only.

The maximum wire gauge allowed for power input and output is 12 AWG.

The maximum wire gauge allowed for two-wire communication and unshielded twisted pair (UTP) is 16 AWG.

8

C2473M-D (10/06)

Image 8
Contents IPS-RDPE-2 Remote Data Port Page Contents List of IllustrationsImportant Safety Instructions Required Accessories DescriptionMounting Instructions Wall MountingPole Mounting Cable/Wire Requirements and Connector Locations Refer to for a layout of the data port box connectorsWiring Diagrams Positioning System IPS-RDP PTZ Control Software Upload Positioning System Software Upload Positioning System UTP Receiver Control System AT Control System VC-UTP RX- RX+ TX- TX+ UTP- UTP+ VAC+ Operation Upload IconSpecifications ElectricalProduct Warranty and Return Information ISO9001
Related manuals
Manual 20 pages 48.18 Kb