Wiring Diagrams

The IPS-RDPE-2 is designed to work in both coaxial cable and UTP video transmission systems. Installation configurations include the following:

•Coaxitron Controller with Coax Video

•Coaxitron Controller with UTP Video (Passive Receiver Only)

•RS-422 (D or P) Protocol Controller with Coax Video

–Point-to-Point Configuration

–Home Run Configuration

–Daisy-Chain Configuration

•RS-422 (D or P) Protocol Controller with UTP Video

–Point-to-Point Configuration

–Home Run Configuration

–Daisy-Chain Configuration

Refer to Figures 4 through 11 and select the desired configuration for your installation. Make all equipment connections as illustrated in the drawings.

PTZ CONTROL AND

SOFTWARE UPLOAD

POSITIONING SYSTEM

OR	POWER

TX+ TX- RX+ RX-

VIDEO

OUT

PTZ CONTROL ONLY

IPS-RDPE-2

RX- RX+ TX- TX+	UTP- UTP+
RX- RX+ TX- TX+	UTP- UTP+

VAC+	VAC-	VAC+	VAC-
24	24	24	24

POWER

SUPPLY

VIDEO	VIDEO
IN	OUT

VIDEO

COAXITRON

CONTROLLER

Figure 4. Coaxitron Controller with Coax Video

NOTES:

•Input power for the IPS-RDPE-2 is 24 VAC only. The maximum wire gauge allowed for power input and output is 12 AWG.

•Refer to the manual supplied with the positioning system for wiring distances and coaxial cable requirements.

C2473M-D (10/06)