Pelco DVR5KRP-500, DVR5KRP-400 Hard Disk Drive Replacement, Preparing the Unit to Install a Drive

Page 6

Hard Disk Drive Replacement

PREPARING THE UNIT TO INSTALL A DRIVE

WARNING: The chassis assembly includes parts with sharp edges. To avoid injury, use caution when handling the DVR5100 chassis or components.

1.Log off the system and shut down the machine. The power will turn off automatically.

2.As a precaution against electrostatic shock, remove the power cord from the rear panel of the unit, and then disconnect all devices attached to it. Use the enclosed disposable ESD wrist strap to dissipate ESDs.

3.If your unit is installed in a rack, place the unit on a counter or other flat surface, and then remove the rails.

4.Remove the top cover of the DVR (refer to Figure 4).

a. Remove all 10 screws from the DVR — four screws on each side and two on the back. Set aside the screws.

Figure 4. Removing the Screws

b.Slide the top cover back and lift it up.

Figure 5. Removing the Top Cover

6

C2647M (10/06)

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Hard Disk Drive Replacement Instructions Contents Introduction ModelsParts and Tools Removing the Power Cord Getting StartedESD Protection Hard Disk Drive Replacement Preparing the Unit to Install a DriveRemove the top cover of the DVR refer to Figure Installing a Hard Disk Drive Loosening the Hard Disk Drive CageRemoving the Power Cable C2647M 10/06 C2647M 10/06 DVR5100 Login Screen With Keypad Reassembling the UnitRear Panel Connectors for the DVR5100 Audio Inputs 1 and 2 Audio inputs are assigned as followsTable A. Parts of the DVR5100 Back Panel Video input 9-16 are organized as follows Alarm input 9-12 for videoAlarm input 13-16 for video input 8 channel DVRProduct Warranty and Return Information ISO9001
Top Page Image Contents