Mupgrade Utility
For Network Management Cards
User Manual
8.2The configuration editor
At end of the import, the configuration editor opens automatically. It allows you to edit, change or mask some parameters to prepare your configuration to be exported to your installed UPS / STS base.
The names of the items are the same than in the Network Management Card Web interface. The following syntax is used:
Box is not checked: the page / data will not be overwritten when exporting the file.
Box is checked: the page / data in the uploaded card is overwritten when exporting the file.
Indicate a page with fields separately selectable. None of the fields in the page are selected
Indicate a page with fields separately selectable. All the fields in the page are selected.
Indicate a page with fields separately selectable: Some of the fields in the page are selected.
Proceed as following to personalize your configuration.
1.Import a configuration from a programmed card or open an existing file.
2.Select which parameters need to be duplicated in all your cards.
3.Save your configuration and close the editor.
1.UPS configuration editor
You can attribute an identifier to the configuration.
Check the box, to duplicate the setting in all your cards.
Define all the parameters set in the UPS Control Web page.
Change for this settings can only be done in the UPS Control Web page.
(need to
Check the box to duplicate the UPS Control settings in all your cards.
Mupgrade - User Manual | 34003662EN/CA | Page 14/18 |