Mupgrade Utility
For Network Management Cards
User Manual
1 Introduction
This document describes how to use the Network Management Card Firmware Utility software (Mupgrade) to discover, upgrade and configure Network Management Cards linked to the network.
The following functions are available:
-
-Direct link to the card Web interface.
-Firmware upgrade (single card or multicards)
-Import, modify, save, export Network Management Card configuration (single card or multicards)
-Export / import the list of the installed UPS base.
2 Installation
Mupgrade program is available from the www.apc.com Web site, or on the
Run the Setup.exe file and follow the instructions.
A shortcut is placed in the program menu in the group « Schneider Electric »
Note:
If you have UNIX or Linux platform, you cannot use this software but upgrading is possible through TFTP command. Read the Network Management Card user manual to get more information on this function.
#tftp <Entrer> tftp> mode octet tftp> verbose
tftp> put nmc_gb.bin upgrade@password@username <Entrer> Sent 779120 bytes in 85.3 seconds [73096 bits/s] tftp> quit <Entrer>
Note: TFTP upgrade is only working 66074 products.
3 Best environment to use it
This software utility has the best performance if it is principally used in INTRANET architecture. If used in EXTRANET, some limitations can be discovered because of firewalls existence.
Compatible with Microsoft platforms:
◗Windows 2000
◗Windows 2003
◗Windows XP
◗Windows Vista
◗Windows 2008
◗Window Seven
Mupgrade - User Manual | 34003662EN/CA | Page 3/18 |